电影中国三级片网站,日本成人电影A片

Technology

Knowledge

What problems are likely to occur when the manufacturer of rock plate cutting machine operates again?

發(fā)布：2022/3/2　來(lái)源：　作者：　瀏覽：997次

Generally speaking, when cutting glass, there are many main quality problems, such as scratch, edge collapse, size deviation, etc. sometimes even if you are extra careful, there are other situations. Then, as a manufacturer, let's talk about what problems are likely to occur when the manufacturer of rock plate cutting machine equipment operates again?
Before cutting, the equipment manufacturer of rock plate cutting machine shall remove the sundries on the glass cutting table. During the cutting process, the sundries shall be removed at any time to keep the table clean.
The cutting edge of the tool is seriously worn, so it should be reground on the special tool.
When the cut glass is stacked, it shall be stacked separately as far as possible. For example, when several pieces of glass are stacked together, soft materials such as rubber strips or white paper should be used to separate the glass.
According to the manufacturer of rock plate cutting machine, when stacking glass, first align the lower edge of the glass, and then align the upper edge.
Quality problems of glass itself, such as uneven stress.
When cutting glass, edge explosion often occurs, which affects the cutting quality.
When cutting, if the knife is too heavy, strengthen the actual operation and control the cutting force.
Above, i.e. "what problems are likely to occur when the manufacturer of rock plate cutting machine operates again?" About the content, the above content can be shared with your customers and let them learn. If there is anything you don't understand, please put it forward to us and we will answer it for you.

【字體：大中小】【關(guān)閉窗口】

Disclaimer: if the content is similar or infringed, please notify us in time and thank you for your support

上一篇：沒(méi)有了
下一篇：How to maintain the rock cutting machine? Is there any correct maintenance method?